![]() If you're not sure what to look for, I would suggest opening a ticket with Technical Support to dig into the samld and sslvpnd debug to figure out what's going on. You can configure FortiAuthenticator to be Radius client at Duo-radius server (seems to be the same as on a Fortigate), but the information in docs is very limited: Third-party RADIUS clients After completing FortiAuthenticator setup, please consult the vendors documentation for information about configuring your third-party device as a. If you have checked through all the settings, I would dig deeper into sslvpn and saml debug to find error messages, such as 'failed group matching' or 'The identifier of a provider is unknown to #LassoServer'. Get detailed device health data, enforce adaptive user, device and application access controls, and give your users a secure single sign-on (SSO) experience. > I once had the issue in lab where FortiGate was configured to access an IdP on its IP, but the IdP was configured to reply with its URL in the SAML response, leading to a mismatch and FGT not accepting the SAML response :\ Duo Free provides secure credential theft protection with Duo’s easy-to-use two-factor authentication (2FA). > double-check that you have the correct URLs configured This topic describes how to integrate Identity Administration with your Fortinet FortiGate VPN via RADIUS to add multi-factor authentication (MFA) to VPN logins. > double-check that you have the Duo IdP certificate imported and referenced in the SAML server settings on FGT The FortiGate SAML server config has the correct certificate and URLs ![]() > verify that you have a portal mapping for the group in your VPN settings (and that the portal allows web-mode/tunnel-mode as necessary) To configure the integration of FortiGate SSL VPN into Microsoft Entra ID, you need to add FortiGate SSL VPN from the gallery to your list of managed SaaS. ![]() > verify that the 'VPNtestduo' group is in at least one policy with the SSLVPN tunnel interface as source the DUO VPN group is associated with at least one SSLVPN policy and has a portal mapped Multi-factor authentication (MFA) may also be set up for SSL VPN users, administrators, firewall policy, wireless users, and so on. > double-check that the attribute defined here is one that Duo sends in its response and does contain a username you have the correct username attribute set: You can configure FortiADC to support a Duo RADIUS authentication server. When a remote VPN user starts FortiClient for VPN connection to any spoke node, the on-premise RADIUS service verifies the user credentials. Configuring Duo authentication server support. When the user will try to username ‘Fortinet1’ which does not match with the local user created on. When the user will try to connect with the username fortinet1 which is matching with the local user created on FortiGate, the user will get a prompt for the code. I would suggest double-checking the following: This guide outlines how to integrate Azure multifactor authentication (MFA) to existing on-premise and cloud-based user authentication and VPN infrastructure. On the SSL-VPN group, the LDAP server is configured as a member of the group. The group object should be fine as long as Duo returns a successful authentication to FortiGate, FortiGate should consider the user a member of the 'VPNtestduo' group and act accordingly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |